I know it’s pretty basic but doing the laminated top has really been kicking my butt. I chose to make it from pine as she repairs rugs and sometimes needs to nail them to her bench and this should be easy to nail into and pull the nails back out of. I’m going to apply some poly to the top and hopefully I can finally sign off on this project.
Looking good. If you use Tung oil instead of poly, you could wet the table to swell the nail holes shut every couple of years, and then throw a new coat of tung oil on and be looking brand new again.
Tung Oil finish is mostly just poly anyway, unless you go out of your way to specifically get pure tung oil.
I recommend boiled linseed oil instead of tung oil - I can find real boiled linseed oil. Most tung oil isn’t really tung oil is just sortof looks like tung oil if you are not too picky.
Am I the only one who read “building my wife out of pine”?
I guess that means that you’re
(•_•)
( •_•)>⌐■-■
(⌐■_■)
pining for her
YEEEEAAAAHHHH!!!
Nice job! I always think pine gets a bad wrap.
Did you build the top with breadboard ends that allow for the top to move with the seasons?
