Yeah… there’s a lot of reverse threaded stuff at my work.
La derecha oprime, la izquierda libera.
I’m not sure if it’s a symptom of a mental disorder but I struggle with right vs left to this day. If someone says “turn left” it takes some mental power for me to decipher. But clockwise / anticlockwise is easy for some reason
Dyslexia / dysgraphia
This. I have mild dyslexia and dysgraphia and I refuse to give driving directions. I will point left, say right, and not even realize it and just confuse the shit out of my driver, lol.
Hell, I refuse to accept directions. My navigator will say left, I’ll go right, and they’ll look at me funny. If we’re in my car, we’re using GPS. No exceptions, even if we’re just going 3 blocks.
I’ve found that Driver’s Side/ Passenger’s Side works for me, though I’ve never been to somewhere that drives on the driver’s side of the road, so that could trip me up.
If too much righty tighty then it might become loosy
“little bolt no good anymore” - maybe don’t use caveman strength on an 8mm bolt that holds no weight???
Seen it too many times. The biggest guy on the team grabs the biggest wrench he can find for the smallest fastener on the assembly. Maybe the wrench bends, maybe the head snaps, I’ve seriously considered getting torque limited Allan wrenches.
As a kid it took me a long time to understand what turning right even meant, because when the top goes right, the bottom goes left and the sides go up and down. It doesn’t make sense.
Even in my sixth decade, I beat people about the head with this, becoming the pedant from hell until they finally revert to clockwise and counterclockwise. And if they become specific enough to be “right over the top”, I go, “well, why not just say clockwise and avoid all that ambiguity?”
Being on the spectrum, it took me into my very early teens to even figure out right from left. I was two grades ahead of my peers in math, and could read a map and navigate better than most adults, but I needed a high degree of specificity when it came to physical directions. Any assumptions that were inconsequential to others became massive roadblocks to me due to the innate ambiguity of assumptions.
I think the issue is that the words “clockwise” and especially “counterclockwise” are way too long and therefore people prefer saying “left” or “right”.
Not to mention a rapidly growing segment of the population is unable to read analog 12 hour clocks, so the analogy is not that helpful.
I’ve been wrenching on cars nearly 30 years. I’ve had mechanical maintenance as part of my actual job for a decade now. Two years ago it all finally clicked for me. Clockwise tight, counterclockwise loose.
Clocky locky
I hate righty-tighty lefty-loosy. Depending on whether you’re looking at the top or bottom of the screw, you can see movement to the right or the left. I hate whoever came up with it, and I wish I had been taught the right hand method. It works exactly the same as the electromagnetic right hand rule:
an example of the right hand rule as it relates to a screw threadBasically, you take your right hand, stick your thumb out, and curl your fingers like you’re grabbing a broom handle. Point your thumb in the direction you want the screw to move to. Want to screw something in? Point your thumb towards the thing. Want to unscrew? Point your thumb away from the object the screw is currently in. Then, just look at the way your fingers are pointing! If it helps, squeeze your fingers into a fist and see which way they move. Alternatively, bend your wrist in, and observe which way your fingers are moving. Works every time.
It sounds complicated, but there are plenty of people who are unable to intuitively differentiate from right and left the way they can differentiate up and down. I am one of those people. Thanks to this method, I’ve been able to develop the muscle memory/intuition to know which way to turn a screw.
It’s important to note that this only works for screws that are “right hand threaded.” If the screw is only getting tighter when you’re using this method, then it’s likely reverse threaded, or left hand threaded. If that’s the case, just use your left hand instead of your right hand.
… Neat.
Alas, most people know which way is left or right. In reality it’s more clockwise vs counterclockwise. A good friend of mine needed that hold their left hand up and make an L to remember. Doing it with your right makes a J. Unless you somehow associate Left with Jeft in which case you probably pronounce gif wrong too.
Whichever works for you is great. It doesn’t mean mean everyone is ND or has a learning disability.
