Been daily driving low-profile Gateron switches for a while but wanted to give MX another shot. Mostly so I can use my nice keycaps again. I didn’t buy this filament specifically for this build but I think it works really nicely.
Switches are Ergo Clears, lubed and filmed with (IIRC) 45g springs. They were previously on an Ergodox and barely got any use as I switched to smaller boards shortly after modding them and wasn’t comfortable with desoldering yet, so I’m happy to have finally found a new home for them.
Caps are MT3 Godspeed, case is Overture Matte PLA (light blue and white), printed on the Sovol SV06 Plus.
Colemak-DH? I switched using the Tarmak series of layouts, which change a few keys at a time from QWERTY until you eventually get to Colemak(-DH). Took about 5 weeks to do the gradual switch, then a couple months before I got speed back up to around where I was with QWERTY. But with that method I stayed at a good enough WPM the whole time to not lose any productivity at work.