Been daily driving low-profile Gateron switches for a while but wanted to give MX another shot. Mostly so I can use my nice keycaps again. I didn’t buy this filament specifically for this build but I think it works really nicely.
Switches are Ergo Clears, lubed and filmed with (IIRC) 45g springs. They were previously on an Ergodox and barely got any use as I switched to smaller boards shortly after modding them and wasn’t comfortable with desoldering yet, so I’m happy to have finally found a new home for them.
Caps are MT3 Godspeed, case is Overture Matte PLA (light blue and white), printed on the Sovol SV06 Plus.
How long did it take you to get used to that layout?
Colemak-DH? I switched using the Tarmak series of layouts, which change a few keys at a time from QWERTY until you eventually get to Colemak(-DH). Took about 5 weeks to do the gradual switch, then a couple months before I got speed back up to around where I was with QWERTY. But with that method I stayed at a good enough WPM the whole time to not lose any productivity at work.
I am terrified yet intrigued by this absolute monster
It reminds me of a Stanley Mouse graphic used for a lot of Grateful Dead art
