• themeatbridge@lemmy.world
      link
      fedilink
      arrow-up
      0
      ·
      1 month ago

      If the toilet is actively flushing, water will continue to drain from the tank to the bowl. Closing the flapper stops any additional water from going into the bowl.

      Personally, I prefer to make sure the tank only fills enough to fill the bowl, so as long as you don’t double flush, you don’t need to panic and throw the lid off the tank.

      • deranger@sh.itjust.works
        link
        fedilink
        arrow-up
        0
        ·
        edit-2
        1 month ago

        Those are the only toilets I’m familiar with, at least with regards to maintenance and troubleshooting.

        I’ve cleared a lot of clogged shitters, not once have I had to ensure the flapper is down in the reservoir. That’s “why won’t it stop running” not “why won’t I the water go down”.

        • Darkassassin07@lemmy.ca
          link
          fedilink
          English
          arrow-up
          0
          ·
          1 month ago

          Once the flapper lifts, it won’t close again until the tank empties completely. If the toilet clogs and you try too many times to flush it down instead of breaking out the plunger right away; sometimes the water can’t overflow out of the bowl fast enough to let the tank drain fully, so it just endlessly flows. Doesn’t happen to all toilets, but it’s still good to know when your toilet full of turds just won’t stop dumping water on the floor.

            • themeatbridge@lemmy.world
              link
              fedilink
              arrow-up
              0
              ·
              1 month ago

              Turning off the water will stop the tank from refilling. Closing the flapper stops the water in the tank from going into the bowl.

              I would imagine most people aren’t fast enough on the draw to think about doing this first step.

        • SomeAmateur@sh.itjust.worksOP
          link
          fedilink
          English
          arrow-up
          0
          ·
          edit-2
          1 month ago

          If you flush once and it doesn’t go down no problem, if you (or someone you know) tries to flush again no water will leave but the toilet valve tries to fill the bowl more.

          So step one is to stop a potential flood of nasty water from overflowing to the floor

        • 🇰 🌀 🇱 🇦 🇳 🇦 🇰 🇮 @pawb.social
          link
          fedilink
          English
          arrow-up
          0
          ·
          edit-2
          1 month ago

          Sorry, I see what you mean. In this case, the stopper will stay open until the bowl reaches a certain fill limit, set by a float keeping the thing open; you’re trying to stop the bowl from filling more while it’s clogged so you have to close the valve in the tank manually.

          The image shows the tank almost empty, but in reality it will probably still have enough water in there to cause a mess if you don’t stop it.