Don’t pour hot grease in a glass jar or it’ll shatter and spill hot grease all over your counter and then when you grab a flimsy piece of plastic from the recycling and try to push it on to stop the spill and the plastic collapses and hot grease goes all over your forearm and gives you 2nd degree burns and your floor is covered in broken glass you will regret it.
Eh, a small mason jar is tough enough to handle a few tablespoons of bacon grease or whatever without shattering. But sure, if you’ve got a lot of grease at once, let it cool down first (or better yet, refrigerate the pot roast or whatever it is you’ve made, so that you can just pull the grease off the top of the pot in one hardened puck).
I have had this happen once. Cold jar, didnt let the grease cool enough… was my bad. Same as if you’re going to put it into a metal can while its still really hot, make sure the can isnt sitting on something that will melt.
I think the best advice is “Dont pour the grease while its still hot enough to burn you”
Don’t pour hot grease in a glass jar or it’ll shatter and spill hot grease all over your counter and then when you grab a flimsy piece of plastic from the recycling and try to push it on to stop the spill and the plastic collapses and hot grease goes all over your forearm and gives you 2nd degree burns and your floor is covered in broken glass you will regret it.
I’m not blowing smoke here … that’s great writing. It works well if you imagine voice growing frantic and speaking faster as it goes.
Eh, a small mason jar is tough enough to handle a few tablespoons of bacon grease or whatever without shattering. But sure, if you’ve got a lot of grease at once, let it cool down first (or better yet, refrigerate the pot roast or whatever it is you’ve made, so that you can just pull the grease off the top of the pot in one hardened puck).
I’ve been pouring hot grease in glass jars for decades without having one shatter. You’re severely overestimating the risks
I have had this happen once. Cold jar, didnt let the grease cool enough… was my bad. Same as if you’re going to put it into a metal can while its still really hot, make sure the can isnt sitting on something that will melt.
I think the best advice is “Dont pour the grease while its still hot enough to burn you”
I may be speaking from experience. I only pour grease into cans and foil now.
Are you… speaking from experience?
Got any advice about tubes and if you get something stuck in one?
I use a Pyrex container if I want to safe the grease. Otherwise I make a bowl of aluminum foil, pour it into that, and toss it once it hardens.
That’s why I pour it into the jar in the sink.
That and I’m really messy and the sink is the easiest place to clean up spilled grease.